Four M2 screws positioning holes for easy installation
Specifications:-
Power supply voltage(VCC): 2.0, 3, 5.5 V.
Output high VOH: 0.8VCC V
Output low VOL: 0.3VCC V
Response time (touch mode) : 60 mS
Output Pin Sink Current (@ VCC = 3V, VOL = 0.6V) : 8 mA
Output pin pull-up current (@ VCC = 3V, VOH = 2.4V) : 4 mA
Response time (low power mode) : 220 mS
Size : 24 x 24 x 7.2 mm
Touch Sensor Interface:-
Control Interface: A total of three pins (GND, VCC, SIG), GND to ground, VCC is the power supply, SIG digital signal output pin
Power Indicator: Green LED, power on the right that is shiny
Touch area: Similar to a fingerprint icon inside the area, you can touch the trigger finger.
Positioning holes: 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install, to achieve inter-module combination.
Add your review
Your email address will not be published. Required fields are marked *
