Gust University - Arduino kit ENGG102

Arduino Component    
• 1x UNO R3 Board    
• 5x LED – Blue    
• 5x LED – Red    
• 5x LED – Yellow    
• 1x LED – RGB    
• 8x 220 Ω resistor    
• 5x 10K Ω resistor    
• 5x 1K Ω resistor    
• 1x 10K Ω Pot    
• 1x Buzzer (active)    
• 1x Buzzer (passive)    
• 4x Large button switch    
• 2x Ball tilt sensor    
• 3x Photo Resistor    
• 1x Flame sensor    
• 1x LM35 Temp Sensor    
• 1x IC 74HC595N 16-pin DIP    
• 1x 7-seg LED 1x module    
• 1x 7-seg LED 4x module    
• 1x 8*8 LED Matrix    
• 1x 16×2 I2C LCD Display (4-pin interface)    
• 1x IR receiver    
• 1x IR remote control    
• 1x Servo Motor    
• 1x Stepper driver module    
• 1x Stepper Motor    
• 1x Joystick module    
• 1x Relay module    
• 1x PIR Motion Sensor    
• 1x Analog Gas Sensor    
• 1x ADXL345 Three Axis Acceleration Module    
• 1x HC-SR04 Ultrasonic Sensor    
• 1x DS3231 Clock Module    
• 1x DHT11 Temperature and Humidity Sensor    
• 1x Soil humidity sensor    
• 1x rc522 RFID module    
• 1x RFID card    
• 1x RFID key    
• 40x Pin headers    
• 1x 830-hole Breadboard    
• 10x Dupont connector wires    
• 30x Jumper Wire    
• 1x 6-cell AA Battery pack    
• 1x USB cable  

• dc motor
• air quality / dust sensor